Ridged Ceramic & Zinc Cabinet Pull

T21 Product Code: CR 3320

The Ridged Ceramic & Zinc Cabinet Pull carries a fine fluted texture along its white ceramic body, sold in three sizes — a standalone 35mm knob and two bar pulls up to 147mm centre-to-centre — so the same design can dress a small drawer or a wide cabinet door in one coordinated finish.

The fluting is pressed into the ceramic itself rather than applied as a surface pattern, which is why the ridges catch light evenly around the curve instead of wearing flat where fingers grip it most. Gloss gold zinc-alloy fittings cap both ends, giving the piece a defined edge against the softer ceramic body.

Offering the design across three sizes means you can knob a set of narrow drawers and handle the adjoining cabinet doors without switching materials or finishes partway through a kitchen or wardrobe run — a common ask when different door widths need different hardware lengths but a consistent look.

All three sizes share the same white ceramic body and gloss gold ends, so mixing them across a run of cabinetry — knobs on drawers, the mid handle on smaller doors, the longest on wider ones — keeps the fluted detailing consistent from piece to piece.

• 35mm knob: single-point fixing, suited to narrow drawers and small cabinet doors
• 114mm handle: a mid-size option for standard drawer fronts
• 147mm handle: for wider cabinet doors and larger drawers needing a longer grip

Specification: Material — ceramic body with zinc-alloy fixings; Finish — gloss gold; Colour — white; Sizes — 35mm x 30mm knob, 114mm x 96mm handle, 147mm x 124mm handle.

Can I mix the knob and handle sizes on the same kitchen run?

Yes, that's exactly what the three-size range is built for. Use the 35mm knob on narrow drawers and either handle length on wider doors, and the fluted ceramic detailing and gloss gold ends will read as one consistent set.

How do I clean the ridges without the finish wearing down?

Wipe with a soft, slightly damp cloth along the direction of the flutes; avoid abrasive pads on the gold ends, which can dull the gloss finish over repeated scrubbing.

Is the centre-to-centre measurement the full pull length?

For the two handle sizes, the centre-to-centre figure is the distance between the two fixing screws, which is slightly shorter than the total handle length — check both figures against your existing hole spacing before ordering.